Chipboard Loft Panels - 320 x 1220mm - Pack of 3
Product code: 116420
Not available for delivery
Sorry, this product is not available for delivery
Product added for Click & Collect
Product has not been added for Click & Collect
Click & Collect
Nearest Store
More Stores
Quantity:
1
£15
Stores with both stock and Click & Collect near .
FREE Click & Collect in as little as 15 minutes from over 230 stores
Click & Collect from store in as little as 15 minutes - FREE
Chipboard Flooring Boards for use to overlay existing flooring or as a loft board for storage. With its convenient tongue and groove design, installation becomes effortless, ensuring a seamless process.
Read more
Read less
Saved to Project List
Chipboard Loft Panels - 320 x 1220mm - Pack of 3
added to "My Project List".
You are not logged in to save your list permanently. Until you log in, your list will be saved temporarily and can only be accessed from the device you are using now.
Click & Collect from store in as little as 15 minutes - FREE
Product details
- Depth: 18 mm
- Length: 1220 mm
- Width: 320 mm
- Weight: 15.179 kg
- Moisture Resistant: No
- Interior or Exterior Use: Interior
- Coverage: 1.17 m2
- Structural: No
- Colour: Natural
- Type: Loft panels
- Certifications Met: BS EN 13986
- Pack Quantity: 3
- Brand Name: Wickes
- Supports Sustainability: Contains responsibly sourced timber
Features & benefits
- Tongue and groove design for rapid and easy installation
- The longer side of the boards should be laid at 90° to the joist and the ends of the boards should always meet on a joist. Floor board joints should also be staggered which will add strength to the total floor area
- Boards should be fixed with screws at every joist. To ensure screws do not sit above the floor they should be countersunk and a pilot hole should also be drilled into the floor board which will make the fixing of the floor easier
- Do not fit two ends of the boards between joists (over a void) as this could cause the boards to sag and potentially break if walked on as well as being a weak area in the floor design
- Butt joints must be positioned in the centre of joists
- Using nails rather than screws could potentially cause an issue with the ceiling and plasterboard area below your floor due to excessive hammering
- This product is responsibly sourced and is E1 emissions compliant