Excluding delivery
Excluding delivery
Excluding delivery
Excluding delivery
Made from high-grade timber, our feather edge boards are durable, sturdy and built to last. Each board is expertly designed to ensure maximum strength and security, making it an ideal option for both residential and commercial properties. Our feather edge fence boards are available in various sizes to suit your specific requirements. With their classic yet modern design, they seamlessly blend into any outdoor space, offering privacy and protection. Easy to install and maintain, our feather edge fence is a cost-effective solution that will enhance any property. Make repairs with individual boards or buy our multipacks to create a new outdoor enclosure. And when it comes to the finishing touches, find the perfect paint colour in our selection of fence paint.
How many feather edge boards you need per metre depends on the width of the boards and the overlap needed. Usually, an overlap of 25mm is required, therefore choosing a board width of 150mm means you’ll need 8 feather edge boards per metre, resulting in a coverage of 125mm after overlapping.
To fit feather edge boards horizontally, all you need to do is fix the battens to the frame, leaving around 600mm of space between each one. You’ll want to start from the bottom, making sure each board is level before you begin to overlap each one by roughly 25mm. Then screw or nail each one at the top to allow movement. Continue upwards and always ensure alignment is achieved.
You should always nail feather edge boards on the thicker edge (overlapping edge), around 20mm from the top. Make sure they’re fully secured using stainless steel or galvanised nails but avoid nailing through both boards to allow movement.
They’re used for fencing, typically around a garden. They’re also used to mark boundaries and to maintain privacy.
Measure and mark your cut line on the board
Make sure the board is on a stable surface
Use a handsaw or circular saw, cut slowly along your marked line
Because feather edge boards are narrow at one side, take extra care not to apply too much pressure, especially near the thin edge.
